CPSC, Porter-Cable Announce Recall to Repair Circular Saws
Source: CPSC Recall #06040
Recall Date
2005-11-29
Manufacturer
Porter-Cable, of Jackson, Tenn.
Units Affected
About 196,000 units
Products Involved
Porter-Cable® 7¼-inch MAG-Saw™ Circular Saws
Hazard
The lower guard on these saws could stick in the open position, posing a risk of severe lacerations to consumers.
Remedy
Consumers should stop using the circular saws immediately and contact Porter-Cable for the location of the nearest service center to receive a free inspection and repair, if necessary.
Reported Injuries
None reported.
Sold At
Major home center and hardware stores nationwide from March 2004 through November 2005 for between $130 and $160, depending on the model.
Manufactured In
United States
Full Recall Description
The recall involves Porter-Cable® 7¼-inch MAG-Saw™ Circular Saws with model numbers 324MAG (serial numbers 10001 through 108962), 325MAG (serial numbers 10001 through 014712), 423MAG (serial numbers 10001 through 100371), and 424MAG (serial numbers 10001 through 012690). The model and serial numbers are located on a label on the top of the saws. Units marked with a "T" at the location shown below have been inspected and are not affected by this recall. "Porter-Cable®" is written on the side of these saws.
Data source: U.S. Consumer Product Safety Commission (CPSC) via SaferProducts.gov.
For the most current recall information, check directly with CPSC or the manufacturer.
Last verified: 2026-03-28