CPSC, Lite Machines Corp. Announce Recall of Motor Speed Controller
Source: CPSC Recall #02514
Recall Date
2001-12-31
Manufacturer
Lite Machines Corporation, of West Lafayette, Ind.
Units Affected
375
Products Involved
Fusion 35 speed controllers (shipped with Corona electric helicopter kits)
Hazard
The Fusion 35 motor speed controller may not operate properly, due to a weakness in a batch of integrated circuit (IC) chips. The (IC) chip can become hot and damage the controller. In certain instances, a malfunctioning IC chip can cause the helicopter motor to turn on for the several seconds before the power is disconnected, which can damage the helicopter or cause injury to the operator or bystanders.
Remedy
Consumers should send the Fusion 35 speed controller to Lite Machines for a diagnostic test by the manufacturer. If the unit is defective, it will be replaced free of charge.
Reported Injuries
There were three incidents where the motor came on for several seconds and damaged the helicopter. There have been no injuries.
Sold At
These components were sold with the electric helicopter kits at hobby shops, from November 2001 through December 2001, for about $60.
Full Recall Description
The Fusion 35 speed controller, a small printed circuit board with wires extending from either side, is packed in a clear plastic bag separate from other radio system components, and carries the identification "Fusion 35 #30499" on its front plate.
Data source: U.S. Consumer Product Safety Commission (CPSC) via SaferProducts.gov.
For the most current recall information, check directly with CPSC or the manufacturer.
Last verified: 2026-03-28